查看單個文章

Potentiometers of the solder
舊 06-03-2009   #7
aaawatch
初級會員
實習水手
 
aaawatch 目前離線
註冊日期:
05-20-2009
文章:
13
aaawatch 是普普通通的會員
不錯 Potentiometers of the solder

is a very easily lead to one of the reasons for failure, most of the customers or the use of hand-soldering method, while the Department of Large enterprises to adopt high-frequency sub-solder method. These are some places where we should pay attention Oh. The use of hand-soldering method, Potentiometers time in the welding operation as far as possible in a short period of time, preferably 3 seconds to To be completed within the maximum contact solder iron temperature less than 270 degrees. If time is too long or too high temperature will cause poor contact and other Potentiometers Reasons. Be used with caution when soldering flux should avoid the use of water-soluble flux, otherwise, the oxidation of metals and materials encourage mold. When using high-frequency soldering potentiometers, attention in the plastic parts: for example, dial knob, plastic push handle, plastic handle, such as when the melting point Further requirements to achieve high-frequency temperature, if they can not replace the high temperature components. To avoid additional wiring and when the tin lead solder flow through the circuit board, otherwise easily lead to poor contactpotentiometers.





__________________

replica watches


  回覆時引用此篇文章